2WNTY3 OIL IS VERY POTENT, USE WITH CAUTION.

 

 
 

 

OPERATING INSTRUCTIONS

 

ASSEMBLY

When opening your cartridge, remove silicon covers on mouthpiece and bottom connector. Connect 2WNTY3 cartridge to 2WNTY3 battery by screwing in. Screw in until snug (it is recommended to keep silicon covers and packaging for storage).

 

USAGE

 Once assembled you are good to go, just puff. No manual operation required. For new users, especially those new to cannabis, take a small mouth puff and wait 20 minutes to fully gauge effects.

 

STORAGE

Keep your cartridge and battery away from extreme heat or cold, ideally around room temperature. Avoid extreme changes in altitude to avoid external leaks. When not in use whether being stored at home or on the go, it is recommended to put silicon covers on both mouthpiece and bottom connector. Keep upright when storing for long periods.

 

TROUBLESHOOTING TIPS

 

FLOW ISSUES / DRY PUFFS / BURNT TASTE

It is fairly common for heavy users especially when the flow rate of oil into vaporizing chamber is not sufficient for the amount of large consecutive puffs. This will sometimes create a vacuum causing negative pressure in the oil tank. When this happens simply screw off mouthpiece and pull off the blue plug. Put mouthpiece back on without blue plug and perform short consecutive mouth puffs to reset pressure in tank. This will allow ambient air into the tank and refill vaporizer chamber. Put blue plug back in afterwards once pressure is reset. This issue is also common when the cartridge goes through temperature and altitude changes. 

 

BATTERY GUIDANCE

In order to get the most effective hits from 2WNTY3 cartridges, please purchase our battery here.

If your battery is lighting up when puffing but your cartridge isnt producing vapor, there may be a connection issue. This happens when there is no contact between the heating element and battery even while screwed in. When this happens, take a paperclip or something similar, insert slightly into the hole of the bottom metal ring and drag it out to the point where it slightly protrudes the tip of the cartridge threading. This will ensure that it makes contact with the battery.

Given the potency of our oil and ceramic heating cartridges, they require a more powerful battery and voltage, which most other brands do not have.

If you are using universal batteries, our voltage is 3.5 - 4 Milliamps, however there is no guarantee these will work effectively.

 

 

WE STAND BY OUR PRODUCT

For any 2WNTY3 product related issues please consult the dispensary from which it was purchased or email info@2WNTY3.com

2WNTY3 offers a no hassle exchange policy for any legitimate defects or malfunctions